NT 100-DP-CC Gateway PROFIBUS DP Master to CC-Link Slave

FEATURES

Integrates a subordinate PROFIBUS network trunk in CC-Link Master for up to 125 PROFIBUS slaves Shortest I/O data conversion time lower than 10 ms Device replacement in seconds via memory card based loading Loadable firmware for flexible use of other conversions With USB diagnostic and configuration port

PRODUCT DETAILS
ProductProduct nameNT 100-DP-CC
Part number1718.140
Brief descriptionGateway PROFIBUS DP to CC-Link-Slave
Communication controllernetXnetX 100
Integrated MemoryRAM8 MB SDRAM
FLASH4 MB serial Flash
Memory cardType and sizeSD or MMC card, max. 2 GByte
Power supplySupply voltage24 V DC ± 6 V
Maximum Current at 24 V (typically)130 mA
Typical power consumption3,2 W
ConnectorMini-COMBICON, 2-pin
Reverse voltage protectionyes
Requirement to the power supplyFor UL conform usage: Device shall be supplied by an isolated voltage source
Communication interface 1Communication standardPROFIBUS-DP
Interface typeRS-485, optically isolated
ConnectorD-Sub, female, 9-pin
Communication interface 2Communication standardCC-Link V2.0 and 1.1
Interface typeRS-485
ConnectorCOMBICON, 5-pin
Diagnostic interfaceTypeUSB
ConnectorMini-USB, 5-pin
DisplaysLED displaysSYS System status
APL Application status
COM Communication status
LINK Link, ACT Activity
Operating elementsNetwork addressNetwork address, 2 rotary switches
Permitted ambient conditionsAmbient temperature (operation)0 … + 60 °C
Humidityno condensation permitted
Pollution degreeFor UL-compliant usage: Device must be used in a pollution degree 2 environment
DeviceDimensions (L x W x H)100 x 52 x 70 mm (without connector)
Weightappr. 150 g
Degree of protectionIP 20
Mountingon DIN rail EN 60715
ConformityRoHSYes
UL certificationULThe device is UL 508 certified
UL fileUL-File No E334100
Conformance with EMC directivesCE signYes
EmissionCISPR 11 Class A
ImmunityEN 61131-2:2003

Share this:

Like this:

Like Loading…